MediSense PCx User Manual download pdf (Page 13)

2-6

Place the object to be scanned on a flat surface, by itself. This will

prevent other items from being accidentally scanned.

Press and hold down the Scan button to start the barcode scanner. A

visible red beam will be emitted from the monitor. Slowly move this

beam over the barcode on the item to be scanned. When the monitor

accepts the barcode, it will beep in acknowledgement. Without

releasing the Scan button, look down at the monitor. The operator

can view the data that was scanned by the monitor. Release the Scan

button to stop the scan and continue with the next step.

CAUTION: Never look into the barcode scanner beam or point it

toward anyone’s eyes. The beam could cause permanent

damage to the eye.

Class II and IIa Laser Product: Avoid Long Term Viewing of Direct

Laser Light.

Data Port

The Data Port is located at the bottom of the monitor. This port enables

the monitor to automatically transfer the data through a cable connector

to a PC, laptop, Laboratory Information System (LIS), or Hospital

Information System (HIS).

Battery Compartment

The monitor holds two AA alkaline batteries to power the monitor.

A rechargeable battery pack is also available from MediSense. The

rechargeable battery pack can recharge itself while the monitor is in the

optional docking station. To prolong the battery life of the monitor, the

monitor should be turned off when not in use. If the monitor is left on

and has not been used for 4 minutes, it will automatically shut itself off.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 150 151

No comments

MediSense PCx User Manual Page 13